HVAC in Conway, South Carolina
Compare HVAC contractors in Conway and get up to three free quotes, with no obligation.
What it costs here: a typical furnace-and-AC system replacement in Conway costs $3,526 – $15,034 in 2026, with most homeowners paying around $10,672. Repairs run $139 – $1,392.
- ✅ 100% free, no obligation
- 📋 Up to 3 local quotes
- ⏱ Response within 48h
Get free HVAC quotes in Conway, SC
Describe your project once and receive up to 3 quotes from local HVAC contractors in Conway.
Compare freely, no obligation — always free for homeowners.
- Up to 3 quotes from vetted local HVAC contractors
- Typical response within 48 hours
- 100% free — no obligation to hire
- Your details are never sold to spammers
Request your free quotes Free
Thank you — your request has been received!
A local contractor will contact you shortly with your free, no-obligation quote.
How it works
Describe your project
One short form — project type, ZIP code, a few details.
We match local pros
Your request goes to vetted HVAC contractors serving Conway.
Compare up to 3 quotes
Written bids, typically within 48 hours.
Hire on your terms — or don't
No obligation, and the service stays free.
Conway homeowners see HVAC replacement prices driven by three local factors. Labor and contractor density around Horry County keep labor rates slightly below national averages—Conway’s local cost index is 0.93—so hourly labor and turnaround times are competitive compared with bigger coastal metros.
Housing stock in Conway is a mix of older bungalows and newer subdivisions; many older homes have dated ductwork and limited attic access, increasing replacement labor. Finally, Conway’s long, humid cooling season and proximity to coastal salt air raise equipment sizing needs and corrosion-mitigation measures, which increase system and coil costs compared with dry inland markets.
HVAC replacement cost in Conway: low, typical, high
| Low | Typical | High | |
|---|---|---|---|
| Total project | $3,526 | $10,672 | $15,034 |
| — Labor (≈60%) | $2,116 | $6,403 | $9,020 |
| — Equipment (≈40%) | $1,411 | $4,269 | $6,013 |
Figures assume an average single-family home with usable existing ductwork and a standard-efficiency system. Ductwork changes, high-efficiency equipment and difficult attic access land above these ranges.
Cost by system type in Conway
| System | Installed total | Typical lifespan |
|---|---|---|
| Central AC only | $3,619 – $7,424 | 12–17 yrs |
| Gas furnace only | $2,598 – $9,280 | 15–20 yrs |
| Furnace + AC (full system) | $4,640 – $15,034 | 15–20 yrs |
| Air-source heat pump | $7,424 – $13,920 | 12–15 yrs |
| Ductless mini-split (per zone) | $3,712 – $7,424 | 15–20 yrs |
Cost by home size
| Home size | Approx. cooling capacity | Full system, installed |
|---|---|---|
| Small home (~1,200 sq ft) | 2 tons | $3,155 – $10,022 |
| Average home (~1,800 sq ft) | 3.5 tons | $5,522 – $17,539 |
| Large home (~2,600 sq ft) | 4.5 tons | $7,099 – $22,550 |
Capacity shown is an estimate from floor area only. Correct sizing requires a Manual J load calculation — insist on one before signing any quote.
Why Conway prices run below the national average
Conway carries a local cost index of about 0.93 — HVAC labor, permits and equipment here price roughly 7% below the US average, thanks to competitive labor markets. South Carolina's long, humid cooling season and coastal salt air both shorten equipment life — coastal installations should ask about coil coatings, and inland homes should prioritize humidity control.
Season matters even more than metro: the first heat wave and the first hard freeze create backlogs across South Carolina, and emergency pricing follows. Replacing in the shoulder seasons — spring or fall — regularly saves 10–20% on the same equipment.
HVAC in Conway: systems, climate and permits
Which system types make sense in Conway
Heat pumps are the common, sensible choice across Conway because they efficiently cool during long, humid summers and now provide reliable heating through mild SC winters. Cold-climate heat pumps are usually overkill; modern conventional heat pumps or dual-fuel setups (heat pump plus gas furnace for the coldest days) are practical. Mini-split ductless systems are excellent for room additions, historic bungalows without usable ductwork, or targeted humidity control in bedrooms and basements. For whole-house replacements where ducts are in good condition, a packaged heat pump or a split system (air handler + outdoor unit) is typical. Aim for higher SEER2 ratings (14–18+ depending on budget); each SEER2 step up improves seasonal efficiency in Conway’s long cooling season and reduces operating costs.
Energy, utility and rebate angle
South Carolina utilities and state programs periodically offer rebates and incentives for high-efficiency heat pumps and energy-saving upgrades—check with your local utility for current offers. The federal 25C tax credit (for qualifying electrification equipment and heat pumps) may also apply; save invoices and installation documents. Conway homeowners should weigh long cooling-season electric use and time-of-use or seasonal peak-demand rates that some utilities apply—higher-efficiency SEER2 equipment lowers peak demand costs. For coastal properties near salt spray, ask contractors about coil coatings and stainless-steel fasteners to extend life. Inland Conway properties should prioritize equipment and system controls that address humidity control (two-stage compressors, variable-speed blowers, or dedicated dehumidifiers).
Permits, Manual J, code and HOA notes
Any major replacement in Conway normally requires a permit from Horry County or the City of Conway building department; HVAC replacements that change capacity or duct layout often trigger inspections. A Manual J load calculation is standard practice and required by many contractors to size equipment correctly—insist on a written Manual J to avoid oversizing in a climate with long cooling seasons. South Carolina follows the International Residential Code variants; local amendments may affect ventilation, combustion safety, and equipment clearances. If you live in a neighborhood with an HOA, verify exterior unit placement, screening, and noise rules before installation to avoid rework. Always confirm permit and code requirements with the city/county plan examiners and retain approval documents.
How to hire an HVAC contractor in Conway (and what to avoid)
- Get 3 written bids. Line-item quotes make comparison honest — equipment model numbers, labor, permit, removal and any ductwork.
- Verify license & insurance. Ask for the South Carolina contractor registration/license number and a current certificate of insurance — then check them with the issuing authority.
- Check the paper trail. Manufacturer certifications (Carrier, Trane, Lennox dealer programs, NATE-certified technicians) and a local physical address beat a magnetic truck sign.
- Never pay in full upfront. A deposit of 10–30% is normal; final payment on completed, inspected work.
- Get the warranty in writing. Separate manufacturer (materials) and workmanship coverage — and who honors it if the company changes hands.
🚩 Red flags
- A replacement quote with no load calculation — sizing "by square footage" or "same as the old one" is how homes end up with oversized systems that short-cycle.
- A maintenance visit that turns into an urgent replacement recommendation, with no measurements shown and a discount that expires today.
- Refrigerant top-ups sold repeatedly without ever finding the leak.
- Quotes far below every other bid — the gap usually reappears as change orders or unpermitted work.
HVAC repair costs in Conway
Not every problem needs a new system. Typical repair pricing in Conway:
- Common electrical parts (capacitor, contactor, relay): $139 – $418
- Refrigerant leak diagnosis and repair: $464 – $1,392
- Thermostat Installation Cost: $63 – $464
- HVAC Tune-Up Cost: $65 – $186
Rule of thumb: when repairs approach 25–30% of replacement cost on aging equipment, replacement is usually the better long-term spend. See the full repair cost guide.
How we calculate Conway costs
We start from documented national baselines, size the job to a typical home for this metro, then apply Conway's local cost index (≈0.93). Full details on our methodology page. These are planning ranges, not quotes — a real bid for your specific system beats any model. Want that real number? Get free local quotes.
Frequently asked questions
When is the best season in Conway to replace an HVAC system?
Late spring or early fall are best in Conway. Contractors are less busy than peak summer, permitting is quicker, and you avoid the hottest, most humid weeks. Scheduling outside peak demand can reduce lead times and sometimes labor premiums. If you need urgent work, HVAC repair visits run $139–$1,392 here.
Is HVAC replacement in Conway more or less expensive than the U.S. average and why?
Slightly less expensive overall: Conway’s local cost index is 0.93, so labor and contractor rates tend to be below the U.S. average. However, coastal corrosion protection, humidity control equipment, and older duct repairs can raise costs. Full system replacement ranges $3,526–$15,034; typical cost is $10,672.
Should I choose a heat pump or a gas furnace plus AC in Conway?
For most Conway homes a modern heat pump is the best balance—efficient cooling for long summers and adequate heating for mild winters. Consider dual-fuel if you have very cold snaps or already have gas infrastructure. Use Manual J sizing to decide; mini-splits suit additions or homes without ducts.
How many contractor quotes should I get in Conway before deciding?
Get at least three written quotes from licensed local HVAC contractors. Ensure each includes a Manual J load, equipment model/SEER2 rating, ductwork assessment, coil coating for coastal homes if needed, and permit handling. Comparing scope and warranties matters as much as price.
When does repair make more sense than replacement locally?
Opt for repair if the issue is isolated (compressor start capacitor, thermostat, refrigerant leak) and the system is under 10–12 years with no major duct or coil corrosion. Consider replacement when repair costs approach half the system’s remaining value or the unit is over 12–15 years—full replacements range $3,526–$15,034, so weigh long-term savings versus short-term repair ($139–$1,392 per visit).
How Conway compares to nearby metros
| Metro | Typical replacement | vs Conway |
|---|---|---|
| Greenville, SC | $10,465 | -2% |
| Columbia, SC | $10,350 | -3% |
| Charleston, SC | $11,155 | +5% |
| North Charleston, SC | $11,569 | +8% |
Ready for a real number for your Conway system?
Compare up to 3 free quotes from local HVAC contractors — no obligation, no spam.
Get my free quotes